If your Pool Cleaner shows an error code, here’s what each one means and specific troubleshooting steps:
General Troubleshooting tips:
For any error code, try turning the power switch at the bottom OFF, wait for 5 seconds, then ON again to restart the cleaner.
E1: Left drive motor failure
E2: Right drive motor failure
Troubleshooting: Clean the roller brushes and the drive motor to ensure no debris is left.
E3: Water pump failure
Troubleshooting:
Pull the robot out of the water, turn it off, and check the filter basket for cleaning and rinsing if needed.
Check the water-inlet grille for any obstruction by objects.
Check the pump impeller for damage or blockage by debris.
Turn the main power switch back ON to restart the device.
E4: Control panel communication failure
E5: Infrared sensor failure
E6: Water sensor failure
If the issue continues, please provide:
A photo or short video showing the robot’s behavior