If your Pool Cleaner shows an error code, here’s what each one means and specific troubleshooting steps:
General Troubleshooting tips:
1. Remove the filter basket from the robot.
2. Turn the main power switch OFF, wait a few seconds, then turn it back ON again (power cycle the robot).
You can use this chart to determine which error code is indicated by your light (red light) on the machine.
E1: Left drive motor failure
E2: Right drive motor failure
Troubleshooting: Clean the roller brushes and the drive motor to ensure no debris is left.
E3: Water pump failure
Troubleshooting:
Pull the robot out of the water, turn it off, and check the filter basket for cleaning and rinsing if needed.
Check the water-inlet grille for any obstruction by objects.
Check the pump impeller for damage or blockage by debris.
Turn the main power switch back ON to restart the device.
E4: Water outlet sensor failure
E5: Infrared sensor failure
E6: IMU error
If the issue continues, please provide:
A photo or short video showing the robot’s behavior