The Pool Cleaner M1-AI offers four cleaning modes that determine which areas of the pool are cleaned and how the cleaning path is executed.
1. Floor Only (Cleaning Mode LED - Bottom LED ON)
This mode focuses on cleaning the pool floor using an S-shaped path for most of the cleaning time. Depending on whether a cleaning duration is set, the robot will switch to AI cleaning mode near the end of the cycle or automatically when the battery reaches a lower level.
2. Wall Only (Cleaning Mode LED - Top LED ON)
In this mode, the robot only cleans the pool walls and follows a “U-shaped” climbing path to ensure vertical surfaces are cleaned efficiently.
3. Wall + Floor (Cleaning Mode LED - Two LEDs ON)
This mode first cleans the walls and waterline, then moves to the pool floor for S-shaped coverage. It may switch to AI cleaning near the end of the cycle or when the battery is running low.
4. Full Coverage (Cleaning Mode LED - All LEDs OFF)
This is the most comprehensive mode, where the cleaner sequentially covers the floor, walls, and waterline, including tanning ledges (water depth > 40 cm (1.3 ft)), to ensure full pool cleaning coverage.